Step Six:
Reach
under the
floor panels for the aft floor supports and slide them into position between
the floor guides. Knock them into place until they are at 90 degrees to the
keel.
Step Five:
Locate
the other end of the floor support in the other side and knock into place
until it is at 90 degrees to the keel.
Step Four:
Insert
the forward floor support under the floor panels with the glued square
underneath. Locate one end of the support in between the floor guides on the
side panel
Step Three:
Let the
floors drop gently into the bottom of the dinghy.
Step Two:
Pull
out the other side panel.
Step One: Open
one
side out as far as possible. To stop the panel from falling inwards, gently
angle the bottom of it slightly inboard.
